Darryl Keil Last Activity 2024-10-10 3:42 PM
4 replies, 2042 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
jerrycousins

Posts: 4

Joined: 2018-06-21

User Profile 
Subject : pump maintenance
Posted : 2022-04-21 8:13 PM
Post #38011
hi darryl - hoping you can help me with some general information - i have a gast pump - 24b1 - which i think is 3.5 cfm. have had it for many years and has always worked just fine - until the last press - i could hear the motor click on but it would not spin - did it 3 or 4 times - then finally moved the fins a bit and it did work - of course this is all happening with a press in the bag. wondering if you could tell me some general maintenance things to look at and do - just to make sure all is good inside.
thought i would post this on the forum so others could see it too.
many thanks, jerry


 
^ Top
Darryl Keil

Posts: 1453

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: pump maintenance
Posted : 2022-04-22 2:09 PM
Post #38012 - In reply to #38011
You have a bit of a vane lock, most likely. You need to open the vacuum chamber and sand all the surfaces as well as take out the vanes and sand in the slats with 400 grit sandpaper no oil, just dry


 
^ Top
jerrycousins

Posts: 4

Joined: 2018-06-21

User Profile 
Subject : RE: pump maintenance
Posted : 2022-04-22 5:09 PM
Post #38013 - In reply to #38012
thanks darryl
jerry


 
^ Top
Tim Eastman

Posts: 10

Joined: 2015-12-01

User Profile 
Subject : RE: pump maintenance
Posted : 2023-06-07 11:07 AM
Post #38043 - In reply to #38012
In the same vein, my pump is also old and recently keeps cycling quickly and gets very hot. Not vane lock; it is not a leak in the bag or hose. There is a leak before it gets there.


 
^ Top
Darryl Keil

Posts: 1453

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: pump maintenance
Posted : 2023-06-08 9:43 AM
Post #38044 - In reply to #38043
I would do a test with the pump. Plug in the hose and put your finger over the brass fitting that goes into the bag. See if the pump holds with only the hose hooked up to it. If it holds then you have some form of a flow restriction. If the pump leaks then its either in the back check valve, filter jar or the o ring on the pump end of the hose.
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta