Darryl Keil Last Activity 2024-10-10 3:42 PM
4 replies, 2241 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Anton Gerner

Posts: 45

Joined: 2003-09-04
Location: Melbourne, Australia

User Profile 
Subject : Veneer cutting jig photos
Posted : 2005-03-05 5:52 PM
Post #32095
Finally my veneer cutting jig for my Altendorf Panel Saw is finished!!
I works really really well. The jig sits on the sliding table and is operated by 4 pneumatic cyclinders which are attached to two beams that come down and clamp the veneer REALLY flat.
Although this is a simple jig to make it did cost quite a lot to purchase all the bits and pieces.
I have posted the photos here: www.antongerner.com.au/veneerjig
I have more pictures if you would like to see them, email me at anton@antongerner.com.au

Anton Gerner


 
^ Top
Darryl Keil

Posts: 1453

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: Veneer cutting jig photos
Posted : 2005-03-06 7:02 PM
Post #32097 - In reply to #32095
Anton,

Thanks for posting the pictures of your jig on your web site, looks very well made and effective.

Sincerely
Darryl Keil


 
^ Top
2trees

 
Subject : RE:Veneer cutting jig photos
Posted : 2005-03-07 7:03 PM
Post #32102 - In reply to #32097
What saw blade are you using?

Is there a non skid surface on the bar, rubber,sand paper etc?

Thanks Ron in mass


 
^ Top
Anton Gerner

Posts: 45

Joined: 2003-09-04
Location: Melbourne, Australia

User Profile 
Subject : RE:Veneer cutting jig photos
Posted : 2005-03-08 2:50 PM
Post #32103 - In reply to #32102
Hi Ron,
No the bar is plain MDF and it works fine. There is huge pressure on this thing!
My next improvement is to inlay some rulars into the table to make it easier to line up your veneer when cutting a bundle of veneer to width.

Regards,

Anton Gerner


 
^ Top
norm

 
Subject : RE: Veneer cutting jig photos
Posted : 2005-03-13 5:09 PM
Post #32106 - In reply to #32095
I have made prototype of a portable highly accurate veneer saw with trimming head for the small to medium size shop. I am investigating marketability to the vac bag market(and beyond) particularly for people who do not have 8 -12' ft panel saw and attachment.

Dedicated commercial travelling head veneer saws start at around 18,000 and long bed guillotines alot more.

This unit would a easily be 2/3rd less.
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta