| | |
Mark
|
I had terrible luck (and lost alot of time and materials) with ultralite. The first run through, I had some glue failure (bubbles} and thought maybe I had a lite pass with the roller. I slit the bubbles and injected yellow glue. As i sanded, the heat must have caused more glue failure cause I had bubbles in areas that were previously set. So I doubt myself and order $400 worth of new veneer shipped express because the designer is worried about the deadline. This time I am extra attentive, everything goes ok the first 2 panels, third panel comes out with glue bleed-thru (Unibond) right where the big bubbles are!!! The failure was always oriented with the grain if that helps. I had a bit of luck "sizing" the ultralite. but I couldn't guarantee the end result after finishing so I had to bail on the project and eat a huge loss. }
|
|
