Darryl Keil Last Activity 2025-09-09 11:09 AM
2 replies, 1754 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Jason Klett

Posts: 2

Joined: 2014-03-10

User Profile 
Subject : Unibond 800 catalyst question
Posted : 2014-03-11 9:52 PM
Post #37102
Is there an MSDS available for the catalyst? I am interested in the percentage of ammonium chloride. The other UF glue I was using had it listed as 13% ammonium chloride with the rest being nut shell filler. I would use the ammonium chloride by itself since in my application the filler would cause an excessive glue line. Can I do the same with the Unibond?


 
^ Top
Darryl Keil

Posts: 1455

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: Unibond 800 catalyst question
Posted : 2014-03-12 11:15 AM
Post #37103 - In reply to #37102
If you want to use straight Ammonium Chloride by itself use a ratio of about 100 to 1. I'm assuming you are a fly rod maker? I get this question a lot from fly rod makers.


 
^ Top
Jason Klett

Posts: 2

Joined: 2014-03-10

User Profile 
Subject : RE: Unibond 800 catalyst question
Posted : 2014-03-16 6:53 AM
Post #37105 - In reply to #37103
Thank you, I will try a test piece once I can get things over 70° in my shop. And yes, I am a fly rod maker.
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta