Darryl Keil Last Activity 2025-09-09 11:09 AM
2 replies, 1529 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Klaus Messerer

Posts: 5

Joined: 2005-11-27
Location: Santa Fe, NM

User Profile 
Subject : Leaking Flip-top Press
Posted : 2005-11-27 2:16 PM
Post #32584
I'm a custom furnituremaker in Santa Fe, NM. I just purchased a 4 x 8 Flip-top press from you guys. I think it's a great system. However, one of the corners of the press is leaking, it seals tight if I apply some pressure by hand in that corner. I've resealed the gasket material in that corner with some bag repair cement, but it still leaks. After assembling the table I went ahead and shimmed all around to make sure there are no gaps anywhere between the frame and the table. Do you have any suggestions for me to try in order to get a good seal?

Thanks,
Klaus


 
^ Top
Darryl Keil

Posts: 1455

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: Leaking Flip-top Press
Posted : 2005-11-28 7:32 PM
Post #32587 - In reply to #32584
Klaus,

I think the best thing is to give me a call at 800-382-4109. Its most likely a simple fix which would be better figured out over the phone.

Sincerely
Darryl Keil


 
^ Top
Klaus Messerer

Posts: 5

Joined: 2005-11-27
Location: Santa Fe, NM

User Profile 
Subject : RE: Leaking Flip-top Press
Posted : 2005-12-20 1:18 AM
Post #32643 - In reply to #32584
It's fixed, seems that I reactivated the gasket adhesive with some moisture and it sealed the joint. Darryl was a great help on the phone. What a great company to do business with.

Klaus
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta