Darryl Keil Last Activity 2026-01-12 8:29 AM
2 replies, 1291 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Jeremy

 
Subject : how to cut small pieces of veneer
Posted : 2001-01-29 6:13 AM
Post #30337
I need to cut small pieces of veneer about 20mm x 50mm (3/4" X 2") and join them around an octagon. What is the best way to do this.Thanks



 
^ Top
Tim Taylor

 
Subject : how to cut small pieces of veneer
Posted : 2001-01-30 3:49 PM
Post #30376 - In reply to #30337
: I need to cut small pieces of veneer about 20mm x 50mm (3/4" X 2") : and join them around an octagon. What is the best way to do : this.ThanksDear Steve:Draw lines out from the center of the octigon to the outward points and behond. use an Exacto razor saw with very fine teeth. All of the veneer pieces will have the same angle at both ends. Either cut them by eye and hand or build a small cut off box with that angle.Good luck




 
^ Top
Steve McRoberts

 
Subject : how to cut small pieces of veneer
Posted : 2001-01-30 7:23 AM
Post #30347 - In reply to #30337
I'm no expert but what I've done is make larger sheets with a cross-banding (like poplar). Now I've got something thick and sturdy enough to cut on an arm or table saw. Sinmply cross band on the back side the same thickness.: I need to cut small pieces of veneer about 20mm x 50mm (3/4" X 2") : and join them around an octagon. What is the best way to do : this.Thanks
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta