Darryl Keil Last Activity 2025-02-12 2:48 PM
2 replies, 846 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Harold

 
Subject : Hard to clamp area
Posted : 2002-07-07 8:27 PM
Post #29261
Need to reveneer with crotch Mah. the end (31" X 8"), of square piano. Small piano, with all 4 square corners. Picture of one just like it on ebay #886517201. Top easy to clamp as there is a 3/4" wall, open down 4" inside. Bottom has a 3" wide flat molding clear across which protudes 1/4" I can use long pipe clamps (3 or more)under the entire length, (6 feet) and on each side, but the molding at the bottom makes it a bit difficult. I/we can do this ok, but is there an easier way? I guess contact cement is out? Too big for a bag.



 
^ Top
Darryl Keil

 
Subject : Hard to clamp area
Posted : 2002-07-16 9:55 AM
Post #29289 - In reply to #29261
Harold,Sorry I missed your previous post, somehow I didnt see it. Anyway, there is a technique where you can use vacuum to clamp something that will not fit in the bag by attaching a piece of plastic around the area that you want to veneer and the vacuum draws the plastic against the surface. Its a bit leaky since the item itself is not in the bag which will cause the pump to run continuously to compensate for leaking. SincerelyDarryl Keil: Need to reveneer with crotch Mah. the end (31" X 8"), of square : piano. Small piano, with all 4 square corners. Picture of one just : like it on ebay #886517201. Top easy to clamp as there is a 3/4" : wall, open down 4" inside. Bottom has a 3" wide flat molding clear : across which protudes 1/4" I can use long pipe clamps (3 or more): under the entire length, (6 feet) and on each side, but the molding : at the bottom makes it a bit difficult. I/we can do this ok, but is : there an easier way? I guess contact cement is out? Too big for a bag.




 
^ Top
Harold

 
Subject : Hard to clamp area
Posted : 2002-07-10 3:37 PM
Post #29272 - In reply to #29261
: Need to reveneer with crotch Mah. the end (31" X 8"), of square : piano. Small piano, with all 4 square corners. Picture of one just : like it on ebay #886517201. Top easy to clamp as there is a 3/4" : wall, open down 4" inside. Bottom has a 3" wide flat molding clear : across which protudes 1/4" I can use long pipe clamps (3 or more): under the entire length, (6 feet) and on each side, but the molding : at the bottom makes it a bit difficult. I/we can do this ok, but is : there an easier way? I guess contact cement is out? Too big for a bag? Any best ways or ideas?
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta