Darryl Keil Last Activity 2024-10-10 3:42 PM
1 replies, 1321 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Ron Shultz

Posts: 10

Joined: 2015-09-01
Location: Louisville, GA

User Profile 
Subject : Vacuum frame leaking
Posted : 2015-09-29 7:03 AM
Post #37327
We just finished our table this morning and are trying the frame press out. We have a leak in the one back corner, close to one hinge. It looks like it is leaking between the plastic 'bag' and the black seal we glued on. The vacuum pump cycles about every 90 seconds.

Any ideas what we can do?


 
^ Top
Darryl Keil

Posts: 1453

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: Vacuum frame leaking
Posted : 2015-09-30 10:09 AM
Post #37339 - In reply to #37327
Without talking with you I cant be clear about the details of your leak, but this is what I would do. Unhook the frame from the table and turn it upside down. On the inside of the gasket where it is attached to the membrane, put a small bead of the patch kit glue between the two surfaces, like a little fillet. Let it fully cure overnight and then reattach the frame to the table.
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta