Darryl Keil Last Activity 2025-09-09 11:09 AM
1 replies, 1192 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
David B

 
Subject : air bladder questions
Posted : 2005-12-01 4:12 PM
Post #32594
I have a customer with some speaker enclosures that seem like the perfect application for an air bladder (read: perfect excuse to buy one). However, there are openings in one face that present two questions: how to veneer the inside edge of a round opening (in a panel that also varies in thickness over the width of the opening), and will the openings present any problems when veneering the face using a bag and bladder? Do I pre-cut the veneer and caul material over the openings or let them span the openings?

Thanks in advance for any advice


 
^ Top
Darryl Keil

Posts: 1455

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: air bladder questions
Posted : 2005-12-01 8:32 PM
Post #32596 - In reply to #32594
David,

If you're going to use the air bladder I would pre-cut the veneer around the openings but not the caul.

As far as the inside edge of a round opening that also varies in thickness, I really cant picture what you mean so its difficult to comment on it.

Sincerely
Darryl Keil
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta