Darryl Keil Last Activity 2024-10-10 3:42 PM
1 replies, 900 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Cliff Slater

Posts: 3

Joined: 2005-01-27
Location: Greenville, SC

User Profile 
Subject : veneers both sides
Posted : 2005-01-29 10:06 AM
Post #32018
would it be ok to turn the back side veneer 90 degrees to the front on a panel 1/4 thick?


 
^ Top
Darryl Keil

Posts: 1453

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: veneers both sides
Posted : 2005-01-30 10:14 PM
Post #32022 - In reply to #32018
Cliff,

Better if you didnt, especially on 1/4". You could always do a test piece and let it sit for a few day. I assume this 1/4" panel is going into some kind of frame. You may feel its good enough veneering opposite sides at 90 degrees. For the flattest panel I would run the veneer in the same direction, if its not that critical then you may be OK.

Sincerely
Darryl Keil
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta