Darryl Keil Last Activity 2024-10-10 3:42 PM
1 replies, 1070 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Steve Daynes

Posts: 3

Joined: 2005-01-16
Location: Vancouver, BC

User Profile 
Subject : honeycomb
Posted : 2005-01-16 2:40 AM
Post #31987
Hi Darryl,

Question for you, I have access to some honeycomb panels that are sheeted with carbon fibre on both sides (Aircraft material) super strong, but not that attractive, do you have any experience veneering wood over this or other resins? Or is it trail and error? What sort of edge treatment do you use on your honeycomb panels?

Thank you
Steve


 
^ Top
Darryl Keil

Posts: 1453

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: honeycomb
Posted : 2005-01-16 9:35 AM
Post #31990 - In reply to #31987
Steve,

You should be able to veneer this material fine but only a few glues like polyurethane or epoxy will probably work.

I would edge the honycomb before you veneer it although I edge it when I'm laying up the honeycomb which you cannot do since its already made. So normally there would be two edgings, the sub one when you make the honeycomb panel and the visual one you see.

Sincerely
Darryl Keil
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta