Darryl Keil Last Activity 2025-09-09 11:09 AM
1 replies, 1429 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Dave in Texas

Posts: 16

Joined: 2003-11-06
Location: Central Texas

User Profile 
Subject : DK- Questions on your video
Posted : 2004-06-16 10:46 AM
Post #31591
Daryl-
I have your video on working with veneer. In the video you were straightning the edges of veneer with a router and a jig. Do you have or know where I can get plans for this jig. Also, in the video, you glued up some dyed veneer to make an edge banding. Did you you yellow glue applied to the face of each piece? Could they have been put in the vacuum clamp instead of clamped between two boards?
Thanks- I really got alot of info from the video but I have not had a chance to use the Unibond glue yet.

Dave



 
^ Top
Darryl Keil

Posts: 1455

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: DK- Questions on your video
Posted : 2004-06-16 10:05 PM
Post #31598 - In reply to #31591
Dave,

I dont have detailed plans of the veneer jig but I do have some close up pictures I can e-mail you along with a simple drawing. This should help. If you give me a e-mail address I will be happy to send it along. Send it to vps@vacupress.com

You could just as easily press up the inlay edge banding in the vacuum press. I did apply the glue to just one face of two out of the three pieces.

Sincerely
Darryl Keil
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta