Darryl Keil Last Activity 2026-01-12 8:29 AM
1 replies, 1368 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
J Troth, Jr

 
Subject : pressing raised panels
Posted : 2003-10-28 8:35 AM
Post #31054
A previous post asked about how best to veneer raised panels. Unfortunately, being my first try, I already shaped my panels. My question is should the top caul be the same size as the raised portion of the panel or should it be the same size as the whole panel. What concerns me is if the top caul is the same size as just the raised portion of the panel won't the bag exert enough pressure on the shaped sides to break them off?
thanks, john


 
^ Top
Darryl Keil

Posts: 1456

Joined: 2003-05-22
Location: Maine

User Profile 
Subject : RE: pressing raised panels
Posted : 2003-10-28 6:22 PM
Post #31057 - In reply to #31054
J Troth, Jr

If the panel is just raised on the front side then the back will lay fine on the platen and you can just make the veneer and cover sheet the same size as the raised portion. If its raised on both sides, put little strips around the edges on the back side to take up the gap.

Sincerely
Darryl Keil
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta