Darryl Keil Last Activity 2025-09-09 11:09 AM
1 replies, 1339 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Dan Bullis

 
Subject : Backing Veneer Grain Orientation
Posted : 2001-05-14 10:02 AM
Post #30145
If the top of a round table is veneered with a large marquetry piece in the middle, starburst veneer pattern around the marquetry, then a starburst pattern rim, hopefully I don't need to repeat the same pattern on the bottom of the panel? What should be the grain orientation of the bottom veneer? Based on other messages, I expect to use the same species of veneer on the bottom. Thanks!



 
^ Top
Darryl Keil

 
Subject : Backing Veneer Grain Orientation
Posted : 2001-05-17 11:53 AM
Post #30150 - In reply to #30145
Dear Dan,For practical purposes I just put veneer on the bottom side all going in the same direction. Since the top is a radial, the direction of the veneer on the bottom can go in any direction.SincerelyDarryl Keil: If the top of a round table is veneered with a large marquetry piece : in the middle, starburst veneer pattern around the marquetry, then a : starburst pattern rim, hopefully I don't need to repeat the same : pattern on the bottom of the panel? What should be the grain : orientation of the bottom veneer? Based on other messages, I expect : to use the same species of veneer on the bottom. Thanks!




back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta