| | |
Darryl Keil
|
Dear Larry,Sometimes I think that someone else would answer a particular question better than I would so I leave it.See, I found it very difficult to take a flat sheet and gather it up so it would have some room in the middle without having folds and puckering at the corners. Our solution is to have a pleated heat welded corner (sort of like a shoe box lid with a flange on it) which ends up being a commercial solution. I gathered that Tim was making it himself so I hoped someone esle might have worked this out and would respond to it.SincerelyDarryl Keil: Why won't some body from Vacuum Pressing Systems answer his question?
|
|
