Darryl Keil Last Activity 2025-09-09 11:09 AM
1 replies, 924 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
khashayar naimanan

 
Subject : glueing wood veneers
Posted : 2001-03-19 8:00 PM
Post #30050
I have made four stool tops using a two-part mould and 7 sheets of 1.5mm beech plywood. I have glued these with a water based adhesive called cascamite. This has worked well for the seats but when i applied it to the top veneer sheet, 0.6mm, it warped. I then went on to try a contact adhesive, Evo-Stick but this did not allow me time to bend the veneer. The stool surface is not a flat surface it has a one way bend. i am looking for any advice on glues and the best way to attach a thin top veneer.



 
^ Top
Darryl Keil

 
Subject : glueing wood veneers
Posted : 2001-03-21 8:42 PM
Post #30054 - In reply to #30050
Dear Khashaya,I think the glue your using is fine, but I would veneer both sides of your stool tops to prevent the warping you are having.SincerelyDarryl Keil: I have made four stool tops using a two-part mould and 7 sheets : of 1.5mm beech plywood. I have glued these with a water based : adhesive called cascamite. This has worked well for the seats : but when i applied it to the top veneer sheet, 0.6mm, it warped. I : then went on to try a contact adhesive, Evo-Stick but this did not : allow me time to bend the veneer. The stool surface is not a flat : surface it has a one way bend. i am looking for any advice on : glues and the best way to attach a thin top veneer.




back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta