Darryl Keil Last Activity 2025-09-09 11:09 AM
1 replies, 1125 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Peter Mitchell

 
Subject : Heat set Sheet Glue
Posted : 2002-01-28 1:18 PM
Post #29656
I enjoyed the videos, thank you.Is their a way to use heat set(HS) sheet glue in a vacuum press? I have read that HS sheet glues need high pressure, doesn't the vacuum negate the need for high pressure? Would not a good poly-bag withstandlow temp HS glues.Thanks again. -PM



 
^ Top
Darryl Keil

 
Subject : Heat set Sheet Glue
Posted : 2002-01-30 2:56 PM
Post #29670 - In reply to #29656
Dear Peter,A polyurethane bag can withstand around 160 degrees for short cycles without deforming. If the glue sheet needs a certain amount of pressure it will still need the same, even in a vacuum press. Be aware that most heat set sheet glues do not compare in rigidity to standard veneering glues like urea resin.SincerelyDarryl Keil: I enjoyed the videos, thank you.: Is their a way to use heat set(HS) sheet glue in a vacuum press? I : have read that HS sheet glues need high pressure, doesn't the vacuum : negate the need for high pressure? Would not a good poly-bag withstand: low temp HS glues.: Thanks again. -PM
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta