| | |
Darryl Keil
|
Mike,I have read you post four times and still dont get exactly what you are describing. I may just be thick, but if you could re-word it or better yet fax me a drawing at 207-725-0932 Im sure it come clear, then I could respond.SincerelyDarryl Keil I am working on a peroject to veneer a conference table. It is 16' : x 5'6". I plan on making in two sections. My question is related : to the changing of the grain direction at each end of the table. : The client wants 45 degrees in each of the four corners to provide a : mitered effect. I plan on laying up each side as a whole, laying : the end pieces 90 to the top at each end then cutting from the : center out to each corner. My only concern is whether the seams : from the sides will align at the miter. This is my first large : conference table. Am I heading in the right direction or is there a : better way?
|
|
