Greg B
Posts: 1
Joined: 2024-02-05
Location: Tucson, AZ
 User Profile |
I have 10mil cherry veneer, want to glue to end panels (MDF) of existing cabinets, so I can't use my vacuum press. Panels are 24 x 34 inches. Clamping suggestions needed? I can cut a 1/2" or 3/4" plywood panel to use as a press, but can only apply clamps over a portion of the panel as the cabinets are installed. I can make some clamping cauls to help, but actual pressure from my clamps will be limited to top and front areas (counter top is removed, as are drawers and doors. I have Unbond One glue in hand. and am hesitant to use Contact Cement based on forum cautions.
|
