Darryl Keil Last Activity 2026-01-12 8:29 AM
0 replies, 660 viewings
 
back
Navigate threads:
< Previous Thread :: Next Thread >
 
^ Top
Dan Minzner

 
Subject : jointing veneers
Posted : 1999-07-27 5:12 AM
Post #30198
I purchased one of these trimmers and use it with the fence to trim panels after being veneered. As for cutting joints with it, I've never used it for that. After many years of frustration I finally broke down and bought a veneer saw. It was costly but worth it. The saw works like a gillatine but instead uses a saw cut followed by a cutter head to clean the cut. Perhaps you could mimmic this by joining your edge after you cut it on your table saw. Burls can be the most difficult to cut. I still cut them one leaf at a time with a sharp utility knife.
back
Navigate threads:
< Previous Thread :: Next Thread >
Legend      Notification  
Administrator
Forum Moderator
Registered User
Unregistered User
 Toggle e-mail notification


Logo by MAZY
Running MegaBBS ASP Forum Software v1.5.14b public beta